App | AlphaFly

📄️ Firmware Flasher Tab

This tab is used to update the flight controller's Firmware.

A place for basic settings and flight controller information. The setup tab is the first tab you see

You will have multiple different devices and peripherals connected to your flight controller UART ports,

This is where most of the main configuration of your flight controller will be done. This includes things

Set up all your power and battery related settings. Set the voltage and current sensor sources and

Failsafe is the action your craft takes when it loses connection to the transmitter.

Presets offer an easy way to configure your settings. They are short snippets of CLI commands that can be

Configure the PID controller settings, Filter settings, as well as the rates.

A receiver is a device that (as its name suggests) receives data from a transmitter, usually your

Modes are used to enable or disable features and trigger FC actions using AUX channels switches. Modes are enabled

Sorry; this Вики page has not yet been written.

Servos Tab

Set up your GPS settings here. GPS is used in AlphaFly for GPS Rescue and showing GPS Coordinates in the OSD.

Configure motor and ESC settings. Change motor direction and mixing, and set up advanced telemetry and flight features

AlphaFly OSD allows the pilot to view in-flight information and telemetry data overlaid onto their FPV camera feed.

Configure the video transmitter (VTX) using this tab. It allows setting of the power, band, channels, etc.

Sorry; this Вики page has not yet been written.

Sorry; this Вики page has not yet been written.

Sorry; this Вики page has not yet been written.

Sorry; this Вики page has not yet been written.

Sorry; this Вики page has not yet been written.

AlphaFly has a command line interface (CLI) that can be used to: